Extron Electronics MS9200P - Manual (Page 72)

HD Player Chapter 12: Remote Control Protocols
72 Rev. 6.8
To Run Telnet
1. Click the Windows Start icon on your desktop
2. Select Run. The window below opens:
3. Enter “Telnet” in the text box and click the OK button
The Telnet window appears:
Enter your commands using the Command Structure shown in the following section.
NOTE: The HD Player currently supports a single HD output. To allow for future expansion and to provide
compatibility across all Electrosonic Player products, the Telnet protocol requires a channel number. This
parameter should be set to 1 in the single channel version unless it has been changed using the Base Channel
Number setting in the Channel Properties window.
Command Structure
The basic structure for a telnet command is as follows:
KeyWord
The channel no (channel number) is mandatory. For the HD Player use 1 unless you have changed the Base
Channel Number setting in the Channel Properties window (Refer to Chapter 5: HD Player Configuration).
The parameter is only used on some commands. For instance, it could be a chapter number.
The terminator can be either a Carriage Return, a Carriage Return & Line Feed, or a NULL (0x00).
Commands are not case sensitive.
NOTE: In the following Command Reference Chapter = MPEG File