Extron Electronics MS9200P - Manual (Page 47)

HD Player Chapter 6: Timecode
47 Rev. 6.8
Stop At
Select the Stop At option set a stop point for the timecode. This time can be before or after the end of the video
output. This might be used for controlling “post show” equipment such as fading house lights up. The Stop At
time is independent of the length of the MPEG clip. Stop At can be used to stop the timecode while the clip is still
playing, or extend the timecode after the clip has ended.
The following examples show some typical uses of the timecode generation options:
 Generate a timecode starting at 01:00:00:00 when the play command is received.
 Generate a timecode starting at 01:00:00:00 when the play command is received, but delay start of the
video playing until 01:00:10:00.
 Generate a timecode starting at 01:00:00:00 when the play command is received. Start the video 10
seconds later (10 second delay) and run the timecode on until 01:05:00:00.