Extron Electronics MS9200P - Manual (Page 73)

HD Player Chapter 12: Remote Control Protocols
73 Rev. 6.8
Command Reference
Configuration Commands
GetPlayerType
This command requests the type of player. The player will respond with:
PlayerType
Where: String1 = The player type from the player type list below.
Number = software version.
The software version will be a numerically increasing version number
Player Type Description
MS9100HD 9100 series based HD players
MS9200HD 9200 series based HD players.
GetChannelCount
This command requests the number of channels present on the player. The player will respond with:
ChannelCount
SetOutputMode
This command is used to set the output mode for the player.
is taken from the output mode table.
Mode Description
Composite Standard definition composite video output
YC Standard definition YC video output
RGBHV RGBHV Component video output
YprPb YprPb component video output
RGsB Component Sync On Green
The Player will respond with:
OK or ERROR
GetOutputMode
This command is used to get the current output mode for the player. The Player will respond with:
OutputMode
String is taken from the Output mode table.