Extron Electronics ImageStar HD - Manual (Page 85)

IMAGESTAR HD USER GUIDE Appendix A: Control Protocol
I460GB issue 4 Page 85
Output Setup Commands
SetOpMode
Function Sets the output format for all four output channels.
Format SetOpMode=<mode number>,<genlock mode>,0,0,0,0\r
Arguments <mode number> is a number representing the required output type:
0 = VGA (640x480) 50Hz
1 = VGA (640x480) 59.94
2 = SVGA (800x600) 50Hz
3 = SVGA (800x600) 59.94Hz
4 = XGA (1024x768) 50Hz
5 = XGA (1024x768) 59.94Hz
6 = 1152x870 50Hz
7 = 1152x870 59.94Hz
8 = SXGA (1280x1024) 50Hz
9 = SXGA (1280x1024) 59.94Hz
10 = SXGA+ (1408x1050) 50Hz*
11 = SXGA+ (1408x1050) 59.94Hz*
16 = HD 720p (1280x720) 50Hz
17 = HD 720p (1280x720) 59.94Hz
18 = WXGA (1376x768) 50Hz
19 = WXGA (1376x768) 59.94Hz
20 = WXGA (1280x768) 50Hz
21 = WXGA (1280x768) 59.94Hz
22 = PAL (704x574I) 50Hz
23 = NTSC (704x482I) 59.94Hz
24 = 1080i (1920x1080I) 50Hz*
25 = 1080i (1920x1080I) 60Hz*
26 = 1080i (1920x1080I) 59.94Hz *
NOTE: Modes marked * provide outputs on channel 1 and 2 only.
<genlock mode> is a number representing the genlock function:
0 = Genlock disabled (always use for RGB graphics)
1 = Genlock enabled and locked to the active YPrPb/YCrCb input
2 = Genlock enabled and locked to the active CVBS or S-Video input
Example SetOpMode=5,1,0,0,0,0\r
Configures all four outputs to XGA 59.94Hz with RGB genlock enabled.