Extron Electronics ImageStar HD - Manual (Page 34)

Section 3: Configuration IMAGESTAR HD USER GUIDE
Page 34 I460GB issue 4
Introduction & Overview
ImageStar HD Configuration is a Windows software application that is used to configure the inputs
and outputs of the ImageStar HD image processor.
NOTE: For more detailed information about the control protocol used by ImageStar HD and how to
control it via HyperTerminal, refer to Appendix A.
Installing the ImageStar HD Configuration Software
ImageStar HD Configuration can be installed on any suitable PC or laptop provided that the following
minimum requirements are met:
Operating System: Windows XP (service pack 2) with .NET framework
Network Port: Ethernet 10Mbps or higher
Free Disk Space: At least 10MB
Optical Drive: CD-ROM compatible
The application installer is located on the ImageStar HD System Disc. Insert the disc into the optical
drive on your PC or laptop and wait for the disc browser to run automatically. If the browser doesn’t
run, or you have disc auto play disabled, run the setup.exe file located on the root of the System Disc.
Follow the onscreen instructions to perform the installation.
Starting the Application
Once ImageStar HD Configuration has been installed it can be run from the main start menu:
Click on Start | All Programs | Electrosonic | ImageStar HD Configuration