Extron Electronics ImageStar HD - Manual (Page 57)

IMAGESTAR HD USER GUIDE Section 3: Configuration
I460GB issue 4 Page 57
Updating an ImageStar HD (Input/Output Settings)
Any changes that you make to the network settings in ImageStar HD Configuration are not
automatically sent to the actual ImageStar HD device. To implement any new settings you must first
‘connect’ to the device and then ‘update’ it.
To connect to an ImageStar HD…
In the Network window, click the Local Name of the required device.
Click the Network menu and choose Connect (or Connect All to connect all devices at once).
The
Status of the device will now show Connected:
NOTE: If the connection attempt fails for any reason, the following message will appear:
To disconnect from an ImageStar HD…
In the Network window, click the Local Name of the required device:
Click the Network menu and choose Disconnect (or Disconnect All to disconnect from all
devices at once).
The
Status of the device will now show Not connected:
NOTE: If the following message appears it indicates that the device was already
disconnected: