Extron Electronics ImageStar HD - Manual (Page 53)

IMAGESTAR HD USER GUIDE Section 3: Configuration
I460GB issue 4 Page 53
Add a Clip
A clip defines the area or window that the source input occupies on the target display. For example, if
your target display is arrange as 2x2 screens, typically the clip will be sized so that it fills the entire
display.
Click the button to select the Clip Layer.
Click the button to select Add Clip mode.
Click in the Wall Layout window – each click will add a new clip to the layout.
To turn off Add Clip mode, click the button.
Move or resize the clip into the required position by simply clicking and dragging the handles.
NOTE: The arrow keys can also be used to move the clip in increments of 10 pixels.
To delete a clip from the layout, click on it and press the Delete key (or choose Delete from
the Edit menu).
To precisely adjust the position of a clip, double click the clip to open its Properties dialog (or
choose Properties from the Edit menu).
Adjust the Top and Left pixel coordinates to alter the position and Height and Width values
to alter the size, and click OK.
NOTE: Pixel coordinates are measured from the extreme top left corner of the Wall Layout
window, i.e. Top=0, Left=0.
Click the OK button.