Extron Electronics ImageStar HD - Manual (Page 77)

IMAGESTAR HD USER GUIDE Appendix A: Control Protocol
I460GB issue 4 Page 77
SaveNetwork
Function Commits new network settings (using IPADDSet, MASKSet and GatewaySet) to
the ImageStar HD flash memory.
NOTE: The device must be rebooted after issuing this command before it will start
using the new settings.
Format SaveNetwork=0,0,0,0,0,0\r
Arguments None.
Example SaveNetwork=0,0,0,0,0,0\r
Saves the current network settings to flash memory.
SetDefaults
Function Returns the device setup (excluding network settings) to the factory-set defaults.
All current settings will be lost.
The default settings are:
Output Mode: XGA 60Hz (mode 5) no genlock
Screen Map: 2×2 XGA with no over/underscan or offset
Source Clip: 2×2 XGA from current graphics source
Format SetDefaults=0,0,0,0,0,0\r
Arguments None.
Example SetDefaults=0,0,0,0,0,0\r
Returns the device setup (excluding network settings) to the factory-set defaults
GetVersion
Function Obtains details about the currently installed firmware.
Format GetVersion=0,0,0,0,0,0\r
Arguments None.
Example Type GetVersion=0,0,0,0,0,0\r into the HyperTerminal window and press the
< enter> key. The firmware and flex versions will be displayed: