Extron Electronics ImageStar HD - Manual (Page 41)

IMAGESTAR HD USER GUIDE Section 3: Configuration
I460GB issue 4 Page 41
Rebooting the ImageStar HD
In certain circumstances it will be necessary to reboot the ImageStar HD to ensure that new settings
are correctly implemented. For example:
•
When changing network settings.
• When change the output resolution to or from SXGA+.
IMPORTANT NOTE: The control connection established between an ImageStar HD and ImageStar
Configuration is not maintained following a reboot operation. Therefore, you will need to ‘disconnect’
then ‘reconnect’ to the device to restore the connection.
To reboot the unit…
Ensure that ImageStar Configuration is ‘disconnected’ from the unit to be rebooted.
Disconnect the power to the unit.
Wait for at least 45 seconds and then reconnect the power.
The unit will then go through its initialisation/self-test phase (approx. 30 seconds). Once this is
complete, you can ‘connect’ to the unit again if required.