Extron Electronics ImageStar HD - Manual (Page 13)

IMAGESTAR HD USER GUIDE Section 1: Introduction
I460GB issue 4 Page 13
Rear Panel Features
DISPLAY OUTPUT CONNECTORS
ES5555
2A MAX 2 RGB
1 RGB
DVI-I DVI-I DVI-I DVI-I
12V DC
REG
OUTPUT
Y
C
SVIDEO
3 VIDEO
4 VIDEO
1 4 2 3
SOURCE INPUT CONNECTORS
POWER
SUPPLY
INPUT
USB
CONNECTOR
NETWORK
CONNECTOR
RGB Composite / S-Video
Full details of connector types, pin-outs and specifications can be found in Section 5: Technical Data.
Briefly, these are as follows:
Power Supply Input
The ImageStar HD requires a 12V power supply via this connector. A suitable mains operated power
supply unit (PSU) is provided.
IMPORTANT: When cycling the mains power to the PSU, wait at least 45 seconds after powering
down before powering up again.
Network Connector
Used for device setup/configuration and downloading new firmware.
USB Connector
Used for downloading new firmware.
Source Input Connectors
Input connectors for up to two analog RGB/component video sources, plus up to two Composite
sources or one S-Video source. See pages 27 to 29 for connection methods.
Display Output Connectors
Output connectors for up to four analog or digital display devices. Each output can be mapped to any
position in a tiled display. See pages 30 and 31 for connection methods.
IMPORTANT: Clip-on Ferrites (e.g. Würth part no. 74271132) must be fitted to each output cable as
near as possible to the output connector.