Extron Electronics ImageStar HD - Manual (Page 66)

Section 4: Technical Data IMAGESTAR HD USER GUIDE
Page 66 I460GB issue 4
Source Inputs
RGB Inputs
Function: Two connectors labeled as 1 and 2, allowing up to two analog
component video/graphics sources to be connected.
Connector Type: 15-pin High Density D-type.
Pin-out Details:
Connector Shell = Screen
(View into socket)
11
6
12
7
13
8
14
9
15
10
1 2 3 4 5
Pin 1
Pin Function Pin Function Pin Function
1 Red 6 Gnd (Red) 11 Ground
2 Green 7 Gnd (Green) 12 DDC Data
3 Blue 8 Gnd (Blue) 13 H Sync
4 NC 9 +5V Input 14 V Sync
5 Ground 10 Gnd (Sync) 15 DDC Clock
Mating Connector: 15-pin High Density D-type.
Recommended Cable: SVGA Monitor Cable (overall screen).
Maximum Cable Length: 2.95 metres (9.5 feet)
Signal Type: Component YCrCb, YPrPb, RGB.
Pixel Clock: 10MHz – 165MHz.
Resolution: Graphics: Up to 1600 x 1200 pixels (UXGA).
Video: 525i, 625i, 720p, 1080i, 1080p.
Video Level: 0.7V
RGB Sync Modes: RGsB (sync on green);
RGBS (composite sync);
RGBHV (separate H & V sync).
Sync Level: 0.3V into 75Ω (RGsB, RGBS, YCrCb, YPrPb);
2.0V minimum into 2.2KΩ (RGBHV).
Scan Mode: Interlaced (for video sources);
Progressive (for graphics sources).
De-Interlace Mode: 1i (‘bob’ / single field interpolated)
VIDEO Inputs
Function: Two connectors labeled 3 and 4, allowing up to two composite sources
to be connected, or one S-Video using input 3 for luma (Y) and input 4
for chroma (C).
Connector Type: BNC.
Signal Type: CVBS or YC.
PAL (B,D,G,H,I,M,N,Nc)
NTSC (J,M,4.43)
SECAM (B,D,G,K,K1,L)
Input Setup: Auto detect.
De-Interlace Mode: 1i (‘bob’ / single field interpolated)