Extron Electronics ImageStar HD - Manual (Page 49)

IMAGESTAR HD USER GUIDE Section 3: Configuration
I460GB issue 4 Page 49
Using the Identify Function
The Identify function causes the red source LEDs on the front of the ImageStar HD to flash briefly.
In a multi-processor system this can be used to help identify which device is which.
IMPORTANT: All current wall layout and clip settings will be cleared from the ImageStar HD.
These settings will need to be reapplied following use of the Identify function.
In the Network window, click the Local Name of the required device.
Click the Network menu and choose Identify.
The red source LEDs on the front of the corresponding ImageStar HD will switch to input 1
(for 3 seconds) then to input 2 (for 3 seconds) and finally back to input 1.