Extron Electronics IPCP 505 User Guide - Manual (Page 94)

IPCP 505 • Index 88
model description
SIS command for model
description 63
model name
as shown in the copyright boot-up
message 50
SIS command to request 63
modes
DHCP mode and SIS
commands 65
IR playback mode variable in SIS
commands 60
reset modes and procedures 16
reset mode SIS commands 74
serial communication standard
(RS-232/RS-422/RS-485)
SIS commands 58
serial pass-through mode
SIS commands for 59
verbose (description and SIS
commands for) 66
momentary
relay description and wiring 15
mounting
UL rack mounting guidelines 10
N
nortxe_index.html factory embedded
web pages 36
P
part numbers
SIS command for 63
pass-through
serial pass-through (redirect
mode) 32
SIS commands for 59
passwords
IPCP responses to 51
requirements for 41
password length and characters
54
SIS commands for 67
Passwords embedded web page 41
ping
using the ping command in
troubleshooting 49
using the ping command with the
ARP command in IP setup 21
port mapping
resetting to default (reset modes 4
and 5) 17
Port Settings embedded web
page 40
power connector
switched power output port
SIS commands for 62
wiring, polarity, requirements
input power 11
output power 11
R
rack mounting
UL rack mounting guidelines 10
redirect mode
serial pass-through (redirect
mode) 32
relay ports
latching: description and
wiring 15
momentary contact: description
and wiring 15
SIS commands for 61
wiring 15
remapping ports
SIS commands for 68
reserved characters 52
Reset button
Reset button and LED location 9
using to reset the unit 16
resetting the unit
manual reset modes 16
reset after firmware update 82
reset (zap) commands and erase
commands (SIS) 74
reset (zap) commands and erase
commands (SIS) 74
RS-232, RS-422, RS-485 default
protocol and COM port pin
configurations 12
S
s19 file type 77
serial bridging 33
hardware connection (cabling) 34
serial bridge configuration 34
serial communication protocol
COM port defaults 12
SIS commands to set protocol for
each serial port 58
serial pass-through mode
SIS command to configure 59
serial pass-through (redirect
mode) 32
serial ports
advanced control methods 31
direct port access (ports 2001
through 2003) 32
serial bridging 33
serial pass-through (redirect
mode) 32
SIS CP command to configure
parameters for each port 58
wiring COM ports 12
wiring IR/Serial ports 14
SIS commands
commands and responses 57
helpful tips for entering and
encoding 52
symbol definitions for 53
straight-through cable (wiring and
when to use) 13
subnet
default value 13
definition of subnet mask 76
resetting to default (reset modes 4
and 5) 17
SIS commands for setting and
reading 65
Switched 12 VDC power output port
SIS commands for 62
symbol definitions for SIS
commands 53
system requirements 6
System Settings (GlobalViewer web
page) 39
T
TouchLink touchpanel
as part of a system with an
IPCP 2
overview about using with an
IPCP 5
setting up the panel and
configuring the IPCP to work
with it 47
touchpanel
as part of a system with an
IPCP 2
troubleshooting 49