Extron Electronics IPCP 505 User Guide - Manual (Page 14)

IPCP 505 • Hardware Features and Installation 8
Create a new GC project and configure the IPCP 505. See the Global Configurator Help
file.
Set the IP address and subnet mask for the IPCP, and other IP settings.
Define the GlobalViewer Tree location of the unit.
Add the IPCP to the project.
Define e-mail settings and contacts.
Add serial, IR, and Ethernet device drivers.
Configure the ports on the IPCP and assign device drivers as needed.
Configure touchpanel buttons, if applicable, in Global Configurator.
Create a display shutdown schedule.
If a projector is part of the system and if desired, create a display lamp hours
notification e-mail.
Create a display disconnection notification e-mail.
Perform configurations for special applications, if needed.
Save the Global Configurator project/configuration.
Build and upload the configuration.
Test the system.