Xylem WQL-Cond CONDUCTIVITY DATALOGGERS - Manual (Page 52)

Logging WQL-Cond
148 ba75822e01 03/2011
13 Interval: To set the logging interval, click the arrow on the right side
of the setting field. A drop-down menu appears with the possible
intervals. Select the required interval with a mouse click.
If User-defined was selected, click the arrows on the right side of the
selection fields and set the hours, minutes and seconds for the
interval.
14 Start: To set the start of the logging, click the arrow on the right side
of the setting field. A drop-down menu appears with the starting
times. Select the required starting time with a mouse click.
If Delay or Time was selected, click the arrows on the right side of the
selection fields and select the required period of time or set the point
in time.
15 Stop: To set the end of the logging, click the arrow on the right side
of the first setting field. A drop-down menu appears with the possible
settings. Select the required starting time with a mouse click.
If Time period or Time was selected, click the arrows on the right side
of the selection fields and select the required period of time or set the
point in time.
16 Measured value ID: Enter the measured value ID (up to 20
alphanumerical characters, no special characters).
17 Click the Time tab.
18 Select Yes or No for adjustment to PC time. If No was selected, click
the arrows on the right side of the selection fields and set the date
and time for the logger.