Xylem WQL-Cond CONDUCTIVITY DATALOGGERS - Manual (Page 44)

Logging WQL-Cond
140 ba75822e01 03/2011
8 Logging
Listed below are the typical operating steps with which to set up and carry out
a logging job. The chapters where the operating steps are described in detail
are also mentioned.
8.1 Typical sequence of a logging job (checklist)
1 Connect the logger to the PC with the USB cable.
2 Start the WQL-Log program (see section 3.6 S TARTING THE WQL-L OG
PROGRAM ).
3 Register the logger (see section 3.6 S TARTING THE WQL-L OG
PROGRAM ).
4 If a logging job is running, terminate or interrupt it (see section
8.8 M
ANAGING THE LOGGING JOBS ).
5 Erase the logger memory if necessary (see section 8.8 M ANAGING THE
LOGGING JOBS ).
6 Calibrate the logger (see chapter 6 C ALIBRATION IN CONTROL
STANDARD ( DETERMINING THE CELL CONSTANT )
7 Set up the logging job and send it (see section 8.3 S
ETTING THE
PARAMETERS AND STARTING THE LOGGING JOB ).
8 Disconnect the USB cable from the logger.
9 If necessary, start the logger with the key button.
10 Check the operation of the logger based on the behavior of the signal
LED (see section 8.5 S
IGNAL LED AND LOGGER KEY BUTTON ).
11 Tightly close the logger with the cap.
12 Install the logger at the measuring location.
13 After completion of the logging job: Connect the logger to the PC with
the USB cable (see step 1 etc.).