Xylem WQL-Cond CONDUCTIVITY DATALOGGERS - Manual (Page 45)

WQL-Cond Logging
141 ba75822e01 03/2011
8.2 Setting up a logging job - setting parameters
You can set the following parameters for a logging job (i.e. the job to
determine and record measured values according to your requirements over
a certain period of time):
Tab Setting Setting options
(default setting in bold)
Recording Interval z User-defined (set the hours,
minutes, seconds)
z 1 second, 5 seconds,
10 seconds, 30 seconds
z 1 minute, 5 minutes, 10 minutes,
15 minutes, 30 minutes
z 1 hour, 2 hours, 3 hours,
6 hours, 9 hours, 12 hours,
24 hours
Start z Immediately (when the setting mode
is quit and the logger is separated
from the PC program)
z Logger key button
(when the key button at the control
panel of the logger is pressed)
z Delay
Set the time before the logger should
start logging: 1 hour ... 7 days
z Time
Set the date and time
Stop z Memory full (the loggers stops
logging only when the memory is full,
i.e. when 600,000 datasets have
been stored)
z Time period
(1 hour ... 365 days)
z Time
Set the date and time
Measured
value ID You can assign a measured value ID
(consisting of up to 20 alphanumerical
character, no special characters) e.g.
the name of the measuring site).
Default setting: default
This tab provides you with information on the free memory capacity and
battery status.