Password – YSI 5500D-1 User Manual

Page 64

YSI 5X00

127

YSI 5X00

126

Names can contain up to 20 characters.

Use AquaManager to easily configure names using the PC keyboard. See Aqua-

Manager On Line help.

1. Enter Name Devices/Sensors menu

Menus → System → Name Devices/Sensors

2. Use

▲

▼

to scroll and highlight submenus.

Press



to select.

4. Use keypad

to configure name.

5. Press

to save configuration and return to Run Screen.

Notes:

- AquaManager users - Names uploaded in the temperature system name field

within the temperature system tab are displayed at the run screen, configura-

tion menus, and control messages menus.

- Instrument, Aux & Sensor Names are not cleared at Reset to factory menus.

- Relays names are cleared at “reset relays”, “reset all systems”, and “reset to fac-

tory/reset all” service menus.

- The 5X00 default system name is displayed at event, sensor, and calibration

logs, regardless if system name is user configured.

Configuring the 5X00

- At alpha/numeric keypad enter charcter then press “Clear” at keypad and then

press

to clear user configured names.

- Non temperature aux system names can also be configured at: Menus → System

→ Configure Aux →Aux 1-6→Probe Name

- Because of font limitations, 1X2 and 2X3 display formats do not show all

20 characters of a 20 character name. Typically only 13 characters are dis-

played.

- The instrument name is not shown at Run Screen. The instrument name is

shown at relay enable menus.

- Certain menus (i.e. configure aux) display up to 18 characters of the device

name. “...” is shown at the menu if the name exceeds 18 characters.

Password

Menus → System → Password

Enable and set the password in the password menu. Once the password is enabled

and saved, 5X00 system menus are not accessible without first entering the correct

password at the Run Screen. The password can contain up to 12 characters.

request for password to enter menus

password menu

1. Enter Password menu