YSI 5500D-1 - Manual (Page 15)

YSI 5X00
29
YSI 5X00
28
Mount the 5X00
Select surface, rail, or panel mount option. Install the weather shield for outdoor
installations.
Surface Mount
Mount 5X00 to any flat surface using mounting brackets. Mounting brackets and
screws are included with the 5X00.
1. Fasten the mounting brackets to the back of the 5X00 with the mounting
screws - figure 3.2.
2. Tighten the screws, securing the brackets to the back of the 5X00 enclosure.
3. Fasten the 5X00 mounting brackets to the mounting surface with the mount-
ing screws provided - figure 3.2. Make sure screws adequately secure 5X00
to surface.
4. Tighten the screws, securing the 5X00 to the surface.
Figure 3.2
Rail Mount
Mount 5X00 to handrail or pipe 1 to 1.5” (2.5 to 3.8cm) in diameter. The rail mount
kit (YSI model number 6509) includes u-bolts, a pre-drilled metal plate, washers,
and nuts.
1. Drill holes in the mounting brackets to fit the u-bolts. Use the pre-drilled
metal plate as a template.
2. Fasten the mounting brackets to the back of the 5X00 with the mounting
screws as shown in figure 3.2.
3. Tighten the screws, securing the brackets to the 5X00.
4. Place the u-bolts around the rail securing the 5X00 to the pipe or rail by
feeding through the pre-drilled holes on the mounting brackets as shown
in figure 3.3.
5. Secure the metal plate over the u-bolts and around the rail or pipe using
washers and nuts provided.
6. Tighten the screws, securing the 5X00 to the rail.
Figure 3.3
Panel Mount
Panel mount the 5X00 if the 5X00’s front panel is to be mounted on a control panel
or any vertical surface where only the front panel will be accessible from the mount-
ing surface. The panel mount kit (YSI model number 6510) includes the standoffs
and frame necessary to mount the 5X00 to any panel 9.5” l x 7.5” w (~24x19cm).
The space behind the panel must be at least 5.5” (14cm) deep.
WARNING: Disconnect external power to the unit before opening the front panel.
AVERTISSEMENT: déconnectez l’alimentation externe de l’unité avant d’ouvrir
le panneau avant.
1. See Open Front Panel to Access I/O Board - page 42 to remove front panel
from enclosure.
Installation and Wiring Installation and Wiring