YSI 5500D-1 - Manual (Page 38)

YSI 5X00
75
YSI 5X00
74
5X00 Configuration and Monitoring
This chapter provides information on the 5X00’s front panel, navigating menus,
and menu functions.
The front panel - figure 4.1, is the front component of the 5X00 enclosure. The front
panel contains the 5X00 display and seven keys. Use the keys to navigate menus and
instrument system information.
This icon indicates helpful information for AquaManager users and is used through-
out this chapter. AquaManager provides access to 5X00 system information from
a PC. Most 5X00 configuration and monitoring can be done using AquaManager.
See Chapter 5 AquaManager -page 175.
Figure 4.1
Configuring the 5X00
Front Panel Keys
There are seven (7) 5X00 front panel keys - figure 4.1. Use ▲ and ▼ keys to
scroll and highlight menu lists and to scroll through multiple Run Screens. Use 
key to select and enter highlighted submenu item and to hold one of multiple run
screens from scrolling. Hold is not an option when there is only one run screen.
Run screens can be scrolled when held by pressing
▲ and ▼ keys.
Notes:
- Press and hold
▲
and
▼
longer than one second for continuous scrolling.
- Use
▲
and
▼
to scroll and view additional menu items when a scroll bar
appears to right of screen.
- Pressing any of the four bottom keys resets any active alarm system. See
General Alarm - page 124.
Softkeys
Softkey labels appear on the bottom of the display and identify the function of the
buttons below them. Softkey labels change in different menus. Softkey labels and
corresponding softkey functions are listed in table 4.1.
Note:
- Not all menus and screens display four softkey labels. If there is no softkey
label, that softkey has no functionality.
Softkey label Function
Access to Main Menu including:
calibration submenu
system submenu
sensor setup submenu
timers submenus
Display active non timer control & alarm
system(s)
Access to Msg’s (Messages) Menu including:
sensor logs
event logs
calibration logs
Activate Service Hold
Configuring the 5X00