GE Industrial Solutions Control System Toolbox For AV-300, DV-300, AV-300i (AVDV Series) Drives - Manual (Page 14)

2-2
•
Chapter 2 Installation GEH-6405A Toolbox for an AVDV Series Drive
Installing Control System Solutions
For assistance, contact:
Industrial Systems
General Electric Company
Product Service Engineering
1501 Roanoke Blvd.
Salem, VA 24153-6492 USA
Phone + 1 540 387 7595
Fax + 1 540 387 8606
(replace + with the
international access code)
Control System Solutions installs various products for control systems as selected in
the setup program. It is recommended that you exit all Windows programs before
beginning. A dialog box may prompt you for a License Key, which can be found on
the actual CD. Also, you must agree to the standard Software License Agreement for
these products.
A default destination directory is set for all products selected. This directory can be
modified, but only during the first installation. Setup installs the required
components and checks available disk space before copying files. You can also
choose to cancel setup and exit at any time before you initiate the selected products.
À
To install from a CD
Install the desired products
from CD, following the
directions on the screen.
Then, install each product
file. 1. Place the Control System Solutions CD in the disk drive.
2. The Setup program executes automatically.
3. Follow the Setup instructions from the screen.
License Key
Note The License Key dialog box may appear, depending on the products ordered.
Enter the License Key number.
This number is printed on the
actual CD. The number is not
case sensitive.