OSRAM QUICKTRONIC INTELLIGENT DIM CFL User Manual

Page 77

8.1.3 DALI to 1…10 V converter

•

Is it possible to switch and dim
with DALI to 1…10 V converters?

Yes, with the converter both are possible.

•

Can the converter also offer the TouchDim function?

Yes, the converter behaves like a DALI ECG here in TouchDIM-

mode 1.

•

Why does the converter have characteristic changeover?

So that it is possible to compensate for the different behaviours

of incandescent lamps and fluorescent lamps. You should there-
fore choose between the linear characteristic (incandescent lamps)
and the logarithmic characteristic (fluorescent lamps) depending on
whether the converter is operating a fluorescent lamp ECG or a
dimmer for incandescent lamps).

8.1.4 Troubleshooting TouchDIM mode

Before you start troubleshooting, please check each time that the
controller is wired according to the operating manual and that the cor-
responding power supply is on. In the case of luminaires, please also
check the light sources and replace if necessary.

• The ECG are not reacting as expected to switch operations.

If the button was pressed too long (> 1 second), the lamp starts

at the lowest dimmer setting which may be difficult to see in bright
ambient surroundings.

•

Individual luminaires have a different brightness level and
conflict with one another.

→

Manual synchronization of the system:

Long button (>3 s) press (all lamps on).

Short button press (all lamps are switched off).

Long button press (all lamps switch on at minimum dimmer setting

and dim upwards).

•

The ECGs react without any button being pressed.

1. The line between button and luminaire (ECG) is possibly too

long.

A button with glow lamp was used which is not permissible.

•

The motion detection function of the TouchDIM sensor is
not working.

1. The luminaire was switched off by double-clicking the switch

and this has deactivated the motion detection function (holiday
mode)