OSRAM QUICKTRONIC INTELLIGENT DIM CFL - Manual (Page 42)

41
The functions of the OSRAM DLT are:
• Luminaire function test (for production)
• Reading of all DALI parameters (e.g. in the event of complaints)
• Preprogramming of all DALI parameters (e.g. for projects)
• Reading and printing of the unique OSRAM operating unit ad-
dress (OSRAM-ID ! CIN (Chip Identification Number)) of each
QUICKTRONIC INTELLIGENT ECG and printing on barcode
(128-bit) for simplified system commissioning
o Placing the label on the luminaire
o Max. 4 ECGs in a luminaire
o Purpose/Advantage
- Simplified installation of a DALI system (no flashing, start-up
from outside)
- No predefined position of the luminaire (position defined with
ID in the luminaire plan)
- System integrator: Assignment of the ID to the position
Figure 22: Reading and printing of the unique OSRAM control unit
address on barcode
The following section of the software interface shows the DALI param-
eters that can be configured by the DLT. Special attention is drawn
here to the "System Failure Level" and "Power On Level" which come
into play for use in emergency lighting systems: