beautypg.com

OSRAM QUICKTRONIC INTELLIGENT DIM CFL User Manual

Page 31

background image

30

EoL shutdown after Test 2

Asymmetric power test for detecting defective lamp electrodes or

high-impedance lamp paths due to leaks in the glass tube

Chip ID (CIN = Chip Identification Number, serial number) for sim-
ple system installation ! OSRAM DALI Luminaire Tool (DLT): Ad-
dress assignment via CIN possible

EEPROM for backing up settings/parameters even if the mains
supply fails

Lamp replacement without mains reset (automatic lamp reactiva-
tion after lamp replacement) [including HF DIM]

DC operation in the input voltage range of 154-276V/lamp start
above 198V [including HF DIM]

Optimized radio interference suppression: Maintaining the requisite
EMC thresholds with a comfortable safety margin for ease of lumi-
naire installation [including HF DIM]

DALI standard acc. to IEC 62386 -101/-102/-201

1…10 V standard acc. to IEC 60929

3.2

OSRAM DALI ECGs and TouchDIM interface

To realize light controllers as economically as possible, the DALI ECGs
from OSRAM also have the integrated TouchDIM function

11

. It is there-

fore possible to dim and switch DALI ECGs directly with mains volt-
age on the DALI control terminals (TouchDIM Interface = TDI). Only
one commercially available switch is required, the ECG assumes the
control function.

The

changeover between both operating modesTouchDIM or

DALI operation – can only be realized after mains voltage. Hence, it is
not possible to switch between the operating modes via an integrated
safety mechanism during operation. Switching between both operat-
ing modes can take place as often as necessary. TouchDIM must
never be used at the same time with a DALI control system.

TouchDIM offens all the functions of a comfort dimmer:

Soft starting of the lamp (lamp starting at the lowest dimmer setting
(1 % (3 %), lowest luminous flux)

Short press: On/Off

Long press: Dimming

Memory function (light value stored by double-clicking)

All settings are remained even after a power outage

11

TouchDim is not part of the DALI standard