OSRAM QUICKTRONIC INTELLIGENT DIM CFL - Manual (Page 74)

73
• Can a TouchDIM system be upgraded with a DALI control-
ler?
Yes, an upgrade is possible at any time. Changeover of the DALI
ECGs from TouchDIM to DALI takes place automatically after a
power outage on the ECG when the first DALI command is sent.
TouchDIM and DALI control cannot be used at the same time!
• Can the motion function of the TouchDIM sensor be
switched off (holiday mode)?
Yes, the so-called "holiday mode" prevents the lighting system be-
ing switched on by the motion sensor. It is activated by double-
clicking on the switch if the light has not been manually dimmed in
the previous 30 seconds. The motion function is active again if the
luminaire is switched on manually at the switch.
8.1.2 DALI in general
• Do the ECGs have to be addressed in DALI?
No, it can also function without addressing (broadcast mode).
• What is the difference between DSI and DALI?
DSI is a corporate solution, not a general standard like DALI. DSI
does not allow digital addressing so it is not possible to form
groups freely or check individual lamps for faults! Groups have to
be formed by wiring as well as in the case of 1…10 V systems.
• Does attention have to be paid to the group arrangement in
DALI when wiring the system?
No, the groups are generally assigned (addressed) when the sys-
tem is started up.
• Does attention have to be paid to the polarity of the DALI
control line?
When OSRAM DALI control gear is used there is no need to worry
about polarity.
• How can DALI ECGs be addressed?
They can be addressed individually, in groups or all together.
• Can I get feedback messages from DALI ECGs?
Yes, all device settings as well as the device status, such as lamp
faults, can be checked.