OSRAM QUICKTRONIC INTELLIGENT DIM CFL - Manual (Page 73)

72
8.1 DALI part
8.1.1 TouchDIM
• Can the TouchDIM function and a DALI controller be used at
the same time?
No. Either a DALI controller or the TouchDIM function! TouchDIM
and DALI operation are mutually exclusive.
• How do the ECGs behave after a mains voltage failure?
The DALI ECG of the QTi series automatically reestablish the previ-
ous status. Both the switching status (on/off) and the dimmer set-
ting are taken into account here.
• Can devices that do not run synchronously be synchronized
again?
Yes. The procedure is as follows:
Press switch for long period (> 3 s) (all ECGs on).
Press switch for short period (all ECGs are switched off).
Press switch for long period (all ECGs switch on with minimum
dimmer setting and then fade up) ! Long – short – long
• Is it also possible to connect more than one DALI ECGs to a
switch?
Up to 6 ECGs can be controlled by one switch, the number of con-
trol sections is limited to 2. With one DALI repeater, up to 64 DALI
ECGs can be operated in TouchDIM mode.
• How long should the cable be between the switch and the
ECG?
The line length should not exceed 25 meters. In the case of longer
lines, additional measures must be taken in order to suppress in-
terference (e.g. bell transformer).
• Which switches can be used?
All button can be used that are suitable for mains voltage, but no
button with glow lamps.
• Does TouchDIM only work with 230 V AC voltage?
No, TouchDIM control is possible with AC voltages between 10 V
and 230 V (effective value!).
• Can I also use DC voltage for TouchDIM?
No, it must be AC voltage with a frequency between 46 and
66 Hz.
8 Frequently asked questions
(FAQ)