OSRAM Touch DIM PD LI 2P WOS - Manual

Page 1 OSRAM - operating instructions: TOUCH DIM PD LI 2P WOS
General
Safety information
• This product may only be installed by qualified personnel who have been appropriately
trained and who have the relevant authority. The installation personnel must be familiar with
the operating instructions. Power must be switched off before any work is undertaken on
the unit.
• The relevant safety and accident prevention regulations must be observed.
• This product is designed exclusively for control of electronic ballasts from OSRAM type
QUICKTRONIC INTELLIGENT DALI (QTi DALI...DIM) or HALOTRONIC INTELLIGENT DALI
(HTi DALI..DIM). Other usage may destroy this and other connected products.
• No other control components may be connected.
• Max. number of ballasts and max. wire length has to be observed.
• Connection to other voltage levels will destroy the device.
• The product has to be supplied by an AC voltage (no DC allowed). This has to be respected
especially when a UPS system is used.
• ATTENTION!: The motion sensor element is connected to mains, a sufficient isolation
and protection against contact has to be guaranteed. The sensor cable and the PIR sensor
socket apply to low voltage installation regulations of 230V AC. If isolation parts or the
plastic cab of the motion sensor element is damaged, the device has to be put out of
operation.
OSRAM GmbH
Customer-Service-Center (CSC)
Steinerne Furt 62
86167 Augsburg, Germany
Tel. : (+49) 1803 / 677 - 200 (charges apply)
Fax.: (+49) 1803 / 677 - 202 www.osram.com
www.osram.de
Touch DIM PD LI 2P WOS
Motion sensor w/o sensor head