OSRAM VALUE Flex Advanced - Manual

OSRAM GmbH
Steinerne Furt 62
86167 Augsburg, Germany
www.osram.com C1
0
2 3 8
6 9 8
Ensure that the mounting surface is clean and smooth. This guarantees that the allowed operating temperatures are not exceeded.
Module mounted to a thermally conductive surface: Before soldering, tin-plate the cable and solder pads fi rst and solder for max.
3s at 350°C; before every further soldering step, allow the solder point to completely cool down; prevent peeling or shearing
forces. The module is mounted using the double-sided adhesion tape on the reverse. Ensure the surfaces are clean and free of
grease, oil, silicone and dirt particles. Please observe the information from 3M about the recommended primers for various sur-
faces. The attachment materials themselves must be fi rm. Ensure the protective tape is completely removed. If mounted to metal-
lic surfaces, apply insulation between the mounting surface and the module to prevent short-circuits at the solder contact points.
Protect against mechanical and electrostatic loads when mounted.
确保安装表面清洁平滑，这可以确保工作温度不超出限制值。在焊接带锡电缆线及焊盘时，焊接温度350℃最长不
可超过3秒钟，待焊点完全冷却后再进行下一步操作；注意剥离或剪切力度，之后将模块安装在导热面上。模块安
装使用背面双面胶。确保安装表面清洁，无油脂、硅晶或其他不洁净颗粒物。可与3M联系获取有关各种表面使用
信息。所有附带材料本身需要是固定的。确保保护胶条完整移除。如果安装在金属表面，需在安装面与产品之间
进行绝缘隔离处理，以防焊接点间短路。安装时避免机械及静电负载。
A
B
G1
0 4 4
7 9 1 3
LINEARlight
Value Flex Advanced – VF06A
Value Flex Power – VF06P
#11709
black
148 x 210 mm
#11709
black
148 x 210 mm
G10447913_LINEARlight_Flex_Value_VF06A_VF06P_03.indd 4-5 G10447913_LINEARlight_Flex_Value_VF06A_VF06P_03.indd 4-5 11.03.13 11:06 11.03.13 11:06