B&B Electronics WLNN-EK-DP551 - User Manual - Manual (Page 57)

B&B Electronics
Airborne Enterprise WLNN EVB Users Guide 57
LED Configuration Issue Description
Attempt to
communicate with the
Device Server
If an attempt has been made to connect to the Device
Server and the COMM LED does turn ON, this indicates
that the connection was not completed successfully.
There are many potential causes for this, please make
sure the following are true:
Confirm the network host attempting to
connect is on the same subnet as the Device
Server. This is done by making sure the IP
addresses for both are in the same subnet.
Confirm the network is not blocking traffic to
the device by using device type specific
filters (Check with IT for this information).
Make sure there is no policy on the network
that restricts access to the module.
The Device Server can be PINGED from the
network host.
The Network Host can be PINGED by the
Device Server.
The telnet port number on the module
(default 23) matches the one being used to
connect to.