EVS Xedio Dispatcher Version 4.35 - October 2013 User Manual - Manual (Page 12)

1.3. Process Overview
1.3.1. General Working Process
When you want to create and export a storyboard, you will usually apply the following
steps. These steps are explained as simple procedures in the following sections. Click on
the step to jump directly to the corresponding section.
1. Creating an empty storyboard
2. Selecting media
3. Adding sub-clips to the storyboard
4. Adding logs to clips and/or storyboard (optional)
5. Checking the storyboard
6. Exporting the storyboard
1.3.2. Process Overview with File Exceeding the
P2 Card Capacity
When the duration of a single shot record exceeds the capacity of the P2 card or when the
resulting file exceeds 4 GB, the camcorder goes on recording on another P2 card.
This results in multiple contiguous media files automatically detected by Xedio
Dispatcher. They are highlighted in the Thumbnail view of the workspace by yellow
rectangles on the right and/or the left sides of the clip thumbnails.
See section "Overview of the Workspace in Thumbnail View" on page 54.
1.3.3. Process Overview with P2-3D Cards as
Source
Xedio Dispatcher is able to manage 3D media from P2 cards and its transfer to a storage
location.
The process is subject to the following limitations:
• Source must be P2-3D cards.
• Always use a Storyboard or a full media within Xedio Dispatcher.
• Thumbnails will always refer to the 1st P2-3D card.
• Both left and right P2-3D cards cannot be plugged in the Xedio Dispatcher workstation
at the same time. The second card must not be plugged until the first storyboard is has
been transferred to the target.
The process must respect the following sequence of steps:
1. Plug the first P2-3D card in the Xedio Dispatcher workstation (left or right eye card).
2. Make a storyboard (i.e. cut-sequence or shot selection) from this card.
2 1. Introduction
EVS Broadcast Equipment SA Issue 4.35.B - October 2013