AASTRA BluStar 8000i User Guide EN - Manual (Page 61)

Application Menu
41-001389-00 Rev 02 – 04.2012 56
To Configure the LDAP Directory:
About
Provides software, hardware, copyright, restrictions, and limited rights information for the BluStar 8000i terminal.
1. Touch the override server configuration button.
This allows the user LDAP settings to override the LDAP server settings.
2. Enter the LDAP directory name. For example, “acme”.
This name will appear as a folder on the directory screen.
3. Enter the LDAP server name or IP address. For example, “ldap.company.com”.
|
4. (Optional) Enter the LDAP port number. If no port number is entered, the default “389” port will be used.
5. Enter the LDAP base DN. For example, “dc=acme, dc=com”.
The base DN is the initial filter for every LDAP request.
6. Select use login credentials if you want to connect to the LDAP server using the BluStar 8000i user name and password.
OR keep this option unselected and manually enter in a username and password.
Note:
If LDAP authentication is anonymous, the user name and password fields can be left empty.
7. Select only use LDAP directory if you don't want to use the global directory set up by your system administrator.
8. Touch the test button to test the user settings configuration.
If the configuration is successful, there will be a green check mark above the test button.
If the test failed, you will see an error message similar to the ones below.
If you see an error message, go back and re-enter the fields with the correct information.