Olympus IPLEX MX II - Manual (Page 51)

45
Chapter 4 Basic operations
„ Inserting the insertion tube
While observing the monitor screen, carefully check the insertion direction as
you slowly insert the insertion tube into the object being observed. Perform the
angulation operation as required during insertion. Be careful not to apply
excessive pushing force, twisting or tension to the insertion tube.
WARNING
• Be sure to turn the illumination light on during insertion into the object being examined.
• If, after the side view mirror adapter is attached to the IV8630M, the overall observation
image is oriented to the left or right as shown in the figure below, or the image rotates or
fluctuates while the insertion tube is moved, the side view mirror may be about to be
detached from the insertion tube distal end. As continuing the use may cause the side view
mirror adapter to drop from the insertion tube, immediately stop using the insertion tube,
withdraw it gently and reattach the side view mirror adapter securely as described in the
attaching procedure.
• Read and understand the contents of “Important Information – Please Read Before Use”
(page 3) before using the insertion tube. In case of any questions, contact Olympus.
CAUTION
• Using the system under any conditions other than those specified in “Operating Environment”
in “Chapter 9 Specifications” (page 81) in the instruction manual may cause unexpected
accidents that may damage the insertion tube.
• The amount of screen noise may increase under high ambient temperatures.
• If any irregularities are found with the insertion tube operation or other things during the
insertion tube insertion, do not insert the insertion tube any further. If this happens, (release
the angulation lock if it is locked) remove your finger from the [ANGLE] joystick, return the
angulation section to center position and slowly remove the insertion tube.