Olympus IX2-DSU BX-DSU User Manual
Disk scanning biological microscope
DISK SCANNING BIOLOGICAL MICROSCOPE
Petition
Thank you for your adoption of OLYMPUS microscope, this time.
Please read this manual carefully in order to get optimum performance of this microscope
and for safety considerations.
When using microscope, please have this manual by you and keep it with care.
AX
6608
Table of contents
Document Outline
- DISK SCANNING BIOLOGICAL MICROSCOPE
- CONTENTS
- INTRODUCTION- Be sure to read this section for safe use of the equipment. -
- I. System Outline
- II. DSU
- 2 SUMMARY OF OBSERVATION PROCEDURES
- 3 DETAILS OF EACH OPERATION
- 3-1 General Precaution for observation
- 3-2 Selection of fluorescent mirror unit
- 3-3 Table of Combination - Objective lens to each observation and applicable disk
- 3-4 Assignment of operating buttons on body (BX61, BX62 or BX61WI only)
- 3-5 Powering up
- 3-6 Focusing
- 3-7 Changeover of visual mirror unit (front side)
- 3-8 Disk IN/OUT
- 3-9 Shutter OPEN/CLOSE
- 3-10 Changeover of camera mirror unit (rear side)
- 3-11 Filter change
- 3-12 Adjustment of field iris diaphragm
- 3-13 Lamp centering
- 3-14 Camera focus alignment
- 3-15 Power shutdown
- 4 VARIETIES OF OBSERVATION METHODS
- 5 TROUBLESHOOTING GUIDE
- 6 SPECTRAL CHARACTERISTICS OF FILTERS
- 7 SPECIFICATIONS
- 8 ASSEMBLY
- 8-1 System block diagram
- 8-2 Installation of light illuminator
- 8-3 Installation of disk box
- 8-4 Removal of transportation lock
- 8-5 Installation of illuminator
- 8-6 Installation of lamp house
- 8-7 Installation of mercury lamp
- 8-8 Lamp power supply setting
- 8-9 Installation of front side turret
- 8-10 Installation of visual mirror unit (front side)
- 8-11 IN/OUT of rear side turret
- 8-12 Installation of camera mirror unit (rear side)
- 8-13 Disk installation and change
- 8-14 Installation of light shielding tube (BX61, BX62, BX51 or BX52)
- 8-15 Installation of UV-cut plate
- 8-16 Installation of filter or shutter (In case of U-FWR or IX2-SHA)
- 8-17 Filter IN/OUT inside motorized filter wheel
- 8-18 Field iris diaphragm IN/OUT
- 8-19 Installation of camera adapter and filter
- 8-20 Installation of camera
- 8-21 DIP switch settings on control box (BX61, BX62 and BX61W1 only)
- 8-22 Installation of motor drive board
- 8-23 Z board setting and installation