ZyXEL Communications Prestige 645R - Manual (Page 90)

Prestige P645 ADSL Internet Access Router
6-8 IPX Configuration
Figure 6-6 Menu 12.2.1 - Edit IPX Static Route
The following table contains the instructions on how to configure the Edit IP Static Route Menu.
Table 6-3 Edit IPX Static Route Menu Fields
FIELD DESCRIPTION
Route # The number of this static route that you chose in menu 12.2.
Server Name In this field, enter the name of the server. This must be the exact name configured in
the NetWare server.
Active Use the [SPACE BAR] to select Yes to activate or No to deactivate this IPX static
route.
Network # This field contains the internal network number of the remote server that you wish to
access. [00000000] or [FFFFFFFF] are reserved.
Node # This field contains the address of the node on which the server resides. If you are
using a Novell IPX implementation, this value is [000000000001].
Socket # This field contains the socket number on which the server will receive service
requests. The default for this field is hex [0451].
Type # This field identifies the type of service the server provides. The default for this field is
hex [0004].
Gateway
Node In this field, enter the number of the remote node that is the gateway for this static
route.
Hop Count
and Tick
Count These two fields have the same meaning as those in the Ethernet setup.
Menu 12.2.1 - Edit IPX Static Route
Route #= 3
Server Name= ?
Active= Yes
Network #= ?
Node #= 000000000001
Socket #= 0451
Type #= 0004
Hop Count= 2
Tick Count= 3
Gateway Node= 1
Press ENTER to CONFIRM or ESC to CANCEL: