ZyXEL Communications Prestige 645R - Manual (Page 63)

Prestige P645 ADSL Internet Access Router
Remote Node Configuration 4-1
Chapter 4
Remote Node Configuration
This chapter is about parameters that are protocol independent. The protocol-dependent
configuration will be covered in subsequent chapters.
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use menu 4 to set up
Internet access, you are actually configuring one of the remote nodes.
4.1 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1. In the main menu, enter 11 to open menu 11 - Remote Node Setup.
Step 2. When menu 11 appears, as shown below, enter the number of the remote node that you wish to
configure.