ZyXEL Communications Prestige 645R - Manual (Page 75)

Prestige P645 ADSL Internet Access Router
Remote Node TCP/IP Configuration 5-5
Table 5-1 TCP/IP related fields in Remote Node Profile
FIELD DESCRIPTION EXAMPLE
Route Make sure IP is among the protocols in the Route field in
Menu 11.1 - Remote Node Profile. Options are IP, IPX,
IP+IPX and None; although with ENET ENCAP the only
available protocol is IP. IP
Rem IP Address Enter the IP address of the remote gateway in Menu 11.1 -
Remote Node Profile. You must fill in either the remote
Prestige WAN IP address or the remote Prestige LAN IP
address. This depends on the remote router’s WAN IP i.e., for
the (remote) Prestige, the My WAN Addr settings in Menu
11.3 – Remote Node Network Layer Options). For example
(see Figure 5-4), if the remote WAN IP is set to 172.16.0.2 (the
remote router’s WAN IP), then you should enter 172.16.0.2 in
the Rem IP Address field. If the remote WAN IP is 0.0.0.0,
then enter 192.168.1.1(the remote router’s LAN IP) in the Rem
IP Address field). 0.0.0.0
Edit IP/IPX/Bridge Press the [SPACE BAR] to select Yes in this field and then
press [ENTER] to go to Menu 11.3 - Remote Node Network
Layer Options. No
The following table shows the TCP/IP related fields in Menu 11.3 - Remote Node Network Layer
Options.