ZyXEL Communications Prestige 645R - Manual (Page 66)

Prestige P645 ADSL Internet Access Router
4-4 Remote Node Configuration
FIELD DESCRIPTION EXAMPLE
Encapsulation= PPP refers to RFC 2364, "PPP Encapsulation over ATM
Adaptation Layer 5". If RFC 1483 ("Multiprotocol Encapsulation
over ATM Adaptation Layer 5") or ENET ENCAP are selected,
then the Rem Login, Rem Password, My Login, My
Password, Edit PPP Options and Authen fields will not be
applicable (N/A). Moreover, ENET ENCAP encapsulation does
not apply for IPX routing. PPP
Multiplexing= Press the [SPACE BAR] to select either VC-based or
LLC-based multiplexing.
LLC-based
Incoming: Rem
Login
Name
Enter the login name that this remote node will use when it calls
your Prestige.
The login name in this field combined with the Rem Node
Password will be used to authenticate this node.
bucket
Incoming: Rem
Password
Enter the password used when this remote node calls your
Prestige. ***
Outgoing: My Login Enter the login name for your Prestige when it calls this remote
node. oscar
Outgoing: My
Password
Enter the password for your Prestige when it calls this remote
node. ***
This field sets the authentication protocol used for outgoing
calls.
Options for this field are:
CHAP/PAP - Your Prestige will accept either CHAP or PAP
when requested by this remote node. CHAP/PAP
CHAP - accept CHAP only.
Outgoing: Authen
PAP - accept PAP only.
Route This field determines the protocols that your Prestige will route.
Options are IP, IPX, IP+!PX and None; although with ENET
ENCAP the only available protocol is IP. IP
Bridge Bridging is used for protocols that are not supported by the
Prestige, e.g., SNA, or are not turned on in the previous Route
field. Select Yes to enable and No to disable. When bridging is
enabled, your Prestige will forward any packet that it does not
route to this remote node; otherwise, the packets are discarded. No
(default)