ZyXEL Communications 650 Series - Manual (Page 393)

Prestige 650 Series User’s Guide
Firmware and Configuration File Maintenance 36-9
36.3.2 Restore Using FTP Session Example
Figure 36-8 Restore Using FTP Session Example
Refer to section 36.2.5 to read about configurations that disallow TFTP and FTP over WAN.
36.3.3 Restore Via Console Port (only for the Prestige 650H/HW)
Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1. Display menu 24.6 and enter “y” at the following screen.
Figure 36-9 System Maintenance – Restore Configuration
Step 2. The following screen indicates that the Xmodem download has started.
Figure 36-10 System Maintenance – Starting Xmodem Download Screen
Step 3. Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...
CCCCCCCCC