ZyXEL Communications 650 Series - Manual (Page 274)

Prestige 650 Series User’s Guide
23-2 General Setup
Figure 23-1 Menu 1 General Setup
Fill in the required fields. Refer to the table shown next for more information about these fields.
Table 23-1 Menu 1 General Setup
FIELD DESCRIPTION EXAMPLE
System Name Enter a descriptive name for identification purposes. This name can
be up to 30 alphanumeric characters long. Spaces are not allowed,
but dashes “-” and underscores "_" are accepted.
Location (optional) Enter the geographic location (up to 31 characters) of your Prestige. MyHouse
Contact Person's
Name (optional) Enter the name (up to 30 characters) of the person in charge of this
Prestige. JohnDoe
Domain Name Enter the domain name (if you know it) here. If you leave this field
blank, the ISP may assign a domain name via DHCP. You can go to
menu 24.8 and type "sys domainname" to see the current domain
name used by your gateway.
If you want to clear this field just press the [SPACE BAR]. The domain
name entered by you is given priority over the ISP assigned domain
name.
zyxel.com.tw
Edit Dynamic DNS Press the [SPACE BAR] to select Yes or No (default). Select Yes to
configure Menu 1.1 — Configure Dynamic DNS (discussed next).
No
Route IP Set this field to Yes to enable or No to disable IP routing. You must
enable IP routing for Internet access. Yes
Bridge Turn on/off bridging for protocols not supported (for example, SNA) or
not turned on in the previous Route IP field. Select Yes to turn
bridging on; select No to turn bridging off. No
Menu 1 - General Setup
System Name= ?
Location=
Contact Person's Name=
Domain Name=
Edit Dynamic DNS= No
Route IP= Yes
Bridge= No
Press ENTER to Confirm or ESC to Cancel: