Image position, Image scale, Rotate 180 – Xerox CX240 User Manual
Page 188
178
Appendix A– Setting Parameters
Image Position
This parameter enables you to change the location of the entire printed
image on the sheet (simplex or duplex).
Image position
uses the following terminology:
•
Rear:
the edge of a sheet at which printing stops, near the rear of the
printer
•
Lead:
the edge of a sheet at which printing begins
The page’s lead and rear edges are determined just after the page is printed
out, before making any change in page orientation.
¾
Select one of the following:
To print your job in the center of the page, click
Center
To set page offsets, click the directional arrows or type
Rear
and
Lead
values
¾
To apply page offset values to both odd and even pages, select the
Same on both sides
check box.
Image Scale
¾
Perform one of the following:
To print the image original size, select
100%
(default)
To fit the image to the selected paper size, select
Fit to Paper
To custom size the image, select
Custom
and
type the percent by
which you would like to proportionally increase or decrease the
image size
Rotate 180
¾
To rotate your job by 180°, select
Yes
.
Tip: Use this option to move duplex page data away from the spine.