Verizon One - Manual (Page 19)

© 2006 Verizon
Verizon One User Guide
19
7.2 Installing the Base Unit on a
Desktop or Flat Surface (cont’d)
Step 3
Follow the Instructions on the
Verizon
One Display (Figure 3).
The
Verizon One display will walk you
through the necessary steps to complete
the set-up of Verizon One and the
installation of your Verizon Online DSL
Service (if required).
7.3 Wall Mounting on a Hollow
Drywall Surface (Optional)
Follow the steps below to mount Verizon
One on a wall:
NOTE: The hardware needed to wall
mount Verizon One is not included with
the product.
1. Obtain two #8 pan-head screws and
two #8 wall anchors.
2. Place the
Verizon One Base Unit
stand against the wall where it is
to be mounted. Using a pencil,
mark one of the two corresponding
screw locations. Mark the other at the
appropriate distance vertically.
3. Drill a 3/16” hole for the wall anchors
and insert. Screw in the #8 screws
until the face of the screws are
approximately 1/8” from the wall.
4. Test-fit the Verizon One Base Unit
swivel stand on the screws and adjust
the screw depth for a sliding fit. Once
the stand fits tightly against the wall,
remove it from the wall.
5. Connect the phone cable (included)
from the jack marked DSL on the rear
panel of the Base Unit to the
telephone wall jack provisioned for
DSL and phone service. This
connection will provide dial tone for
voice services in addition to providing
DSL to your Verizon One.
( Note: Verizon One has a Fax Jack
that can be used to connect additional
telephone equipment such as a fax
machine).
7. Installing the Verizon One Base Unit
Figure 3