Tyco F3200 - Manual (Page 8)

F3200 Installation & Programming Manual Document No: LT0122
Introduction
Page 1-2 5 July 2001 Issue 2.7
1.1 SCOPE
This manual provides information for the personnel responsible for planning, ordering,
installing and programming an F3200 Fire Alarm System. It is assumed that such staff have
been trained to plan/install fire alarm equipment and are familiar with the relevant standards.
The manual is divided into the following chapters:
Chapter 1 Introduction: Information on this manual.
Chapter 2 System Description: A description of the structure of the F3200 FIP.
Chapter 3 Specifications: A detailed specification for the F3200 FIP.
Chapter 4 Ordering Information: Part numbers for the various system components.
Chapter 5 Configuring a FIP: General information and detail on fitting of various links
and resistors when configuring a system.
Chapter 6 Programming: An introduction to programming and a description of the
programming menus and global parameters.
Chapter 7 System Configuration: Detail on specific programmable options in the FIP
I/O.
Chapter 8 Installation & Wiring: Detail of installation and field wiring.
Chapter 9 Applications: Detail of configuration and wiring for specific applications.
Chapter 10 Alignment, Adjustment & Placing Into Operation: Detail on how to adjust an
F3200 in the field and place it into operation.
Chapter 11 Networking: Detail on programmable options for networked F3200s and
NDUs.
Chapter 12 NZ Operation: Describes operation of the NDU in NZ mode.
Chapter 13 Tandem LCD Mode: Describes operation of Tandem LCD mode.
Appendix A 1. Compatible Detectors: A list of detectors which are approved for use
with F3200.
2. Detector Configuration: Detail on AZC and zone configuration for
specific detector types.
Appendix B Configuration Forms: A set of master forms for recording programming detail.