Omron HOME SECURITY SYSTEM - MOTION SENSOR FQM1-MMA21 User Manual
Page 243
220
Analog Input Functions
Section 7-9
A562
00
Analog Out-
put 1 Flags
User Adjustment
Completed
Initial value is 0.
Set to 1 if user performs offset/gain adjustment and
Returns to factory default setting of 0 if adjustment
value is cleared.
Motion
Control
Module
01 to 03
Reserved
---
04
Operating
ON:
ON while the analog output is being changed
by ACC(888).
OFF: Turned OFF when target value is reached.
Motion
Control
Module
05 to 07
Reserved
---
08
Output SV Error
ON:
ON when the output SV setting is outside of
the allowed setting range.
OFF: OFF when the output SV is within range.
Note Only in End refresh mode
Motion
Control
Module
09 to 11
Reserved
---
12
Factory Adjust-
ment Value Error
ON:
ON when the factory-set data stored in flash
memory is invalid.
OFF: OFF when the factory-set data stored in
flash memory is normal.
Motion
Control
Module
13
Reserved
---
14
User Adjustment
Value Error
ON:
ON when the user-set adjustment value
stored in flash memory is invalid.
OFF: OFF when the user-set adjustment value
stored in flash memory is normal.
Motion
Control
Module
15
Reserved
---
A563
00
Analog Out-
put 2 Flags
User Adjustment
Completed
These flags have the same functions as the Analog
Output 1 Flags, above.
Motion
Control
Module
01 to 03
Reserved
04
Operating
05 to 07
Reserved
08
Output SV Error
09 to 11
Reserved
12
Factory Adjust-
ment Value Error
13
Reserved
14
User Adjustment
Value Error
15
Reserved
Word
Bits
Function
Settings
Controlled
by