Oce North America TDS600 - Manual (Page 59)

Use the Océ TDS600 to scan 59
▼ ▼ ▼ ▼ Switch the Océ TDS600 scanner on
1 Set the on/off switch at the front of the scanner to position ‘1’., (see figure 24).
The green LED will be on.
2 The message ’Ready to copy’ appears.
▼ ▼ ▼ ▼ Switch the Océ Power Logic controller on
1 Press the on/off button on the controller, (see figure 25).
2 Press the on/off button on the monitor.
The controller starts up.
Switch the Océ TDS600 scanner off
▼ ▼ ▼ ▼ Switch the Océ TDS600 scanner off
1 Set the on/off switch at the front of the scanner to position ‘0’.
▼ ▼ ▼ ▼ Switch the Océ Power Logic controller off
1 Select the ‘Shut down’ option from the Océ System Control Panel.
2 Switch off the controller and the monitor (see figure 25).
Wait at least 5 seconds before you restart the Océ TDS600.