Oce North America TDS600 - Manual (Page 172)

172 Océ TDS600 Multifunctional Digital System User Manual
Print cut method
Description The Océ TDS600 determines the length and width of each
digital image. The ‘Print cut method’ option allows you to se-
lect one of the following default cut methods:
Standard: The print length corresponds to a standard format,
depending on the media width.
Synchro: The print length is related to the length of the im-
age. This is the factory default value. The minimum print
length is 279 mm.
Custom: The print length is defined by the user. The mini-
mum length is 279 mm. The default value is specified with the
‘Cut length’ option.
Min/max values N/A
Menu path Jobs - Print - Defaults - Sheet - Print cut method
Custom print length
Description The ‘Default paper source number’ option allows you to de-
fine the On the Océ TDS600 you can define a specific cut
length.
The specified cut length is used when the ‘Custom’ cut meth-
od is selected. If custom cut is enabled the copy media length
will only depend on this setting, thus any other influence is ex-
cluded.
The minimum cut length is 279 mm.
Min/max values 279 - 15,000 mm
Menu path Jobs - Print - Defaults - Sheet - Custom print length
Default roll format
Description Use ‘Default roll format’, to define the default media size for
your print jobs.
The default is A0.
The following sizes are available:
A0 to A4 (DIN range)
36 inch (E+)
ISO B1
ISO B2
Note: ‘Default roll format’ works only, when ‘Auto format’
Off is selected in the Media section.
Min/max values 279 - 15,000 mm
Menu path Jobs - Print - Defaults - Sheet - Default roll format