Key operator settings, Key operator settings 151 – Oce North America TDS600 User Manual
Page 151
Océ Power Logic: Settings Editor (for the key operator)
151
Key operator settings
In order to perform special key operator functions, you must log into the
Settings Editor
as a key operator.
As these functions are restricted to a dedicated key operator, a password is
required to access them. The service engineer will provide this password to
you upon installation.
Note:
When you are finished, make certain you log out of the Key operator
mode of the Settings Editor to prevent unauthorized use of the Océ TDS600.
▼
▼
▼
▼
Make key operator settings in the Settings Editor
1
Maximize the Settings Editor on the screen.
2
Log in as key operator.
3
Click on one of the top buttons to display the desired group of settings.
4
Select the setting you want to update in the tree structure.
5
Update the setting in the update area, as required.
Note:
A few settings, such as the defaults for the Custom card, are made
directly from the tree structure area.
6
Click on the ‘Apply’ button.
The new value is now applied for the setting
7
Log out of the Key operator mode when you have finished updating the
settings.