Oce North America TDS600 - Manual (Page 163)

Océ Power Logic: Settings Editor (for the key operator) 163
Cut length method
Description The Océ TDS600 determines the length and width of each
digital image. Use ‘Print cut method’, to select one of the fol-
lowing default cut methods:
Standard The print length corresponds to a standard format,
depending on the media width.
Synchro The print length is related to the length of the image.
This is the default value. The minimum print length is 279
mm or 11 inch.
Custom The print length is defined by the user. The minimum
length is 279 mm or 11 inch. The default value is specified
with the Cut length option.
Min/max values N/A
Menu path Jobs - Copy & File - Defaults - Print card - Sheet - Cut length
method
Custom cut length
Description You can define a specific cut length.
The specified cut length is used when the Custom cut method
is selected. If custom cut is enabled, the copy media length
will only depend on this setting, any other influence is exclud-
ed.
Min/max values 279 - 15000 mm
Menu path Jobs - Copy & File - Defaults - Print card - Sheet - Custom cut
length
Add leading / trailing strip
Description Use the add leading / trailing strip settings to add, by default,
a blank strip at the top or bottom of the image. The print
length will increase accordingly.
‘Add leading strip’ will add a blank strip at the top of the im-
age.
‘Add trailing strip’ will add a blank strip at the bottom of the
image.
By default, no leading or trailing strip is defined.
Note: Adding a trailing strip will only work if the cut method
is set to synchro cut.
Min/max values 0 - 400 mm
Menu path Jobs - Copy & File - Defaults - Print card - Sheet - Strips - Add
leading / trailing strip