Oce North America TDS600 - Manual (Page 30)

30 Océ TDS600 Multifunctional Digital System User Manual
[5] Operator panel in off line mode
The focus is shifted to the Media option (indicated by the shadow effect).
2 Use the Up/Down buttons to select the roll or sheet feeder for which you have
just loaded new media.
3 Press the right selection button to activate the Mat. (Material) option.
The dotted line around the current selection is changed into an uninterrupted
line and the small selection triangles next to the specified material are no
longer dimmed.
4 Use the Up/Down buttons to select the material you just loaded.
5 Press the on line button to put the printer on line again. The printer now knows
which material is used for the specified roll or sheet feeder.
▼ ▼ ▼ ▼ Set media type for manual feed
1 Press the on line button on the printer operating panel to put the printer off line.
The message ‘Off line’ is displayed in the status window.
2 Press the left selection button to shift the focus to the Media option.
A shadow effect is used to indicate that the focus is set to this option.
3 Use the Up/Down buttons to select the Manual option.
4 Press the right selection button to activate the Mat. (Material) option.
The dotted line around the current selection is changed into an uninterrupted
line and the small selection triangles next to the specified material are no
longer dimmed.