Oki B4545 MFP - Manual (Page 47)

47
Setting your terminal
T
ECHNICAL PARAMETERS
As delivered your fax is preset by default. However, you may adjust
it to meet your requirements by resetting the technical parameters.
To set the technical parameters:
29 OK - SETUP / TECHNICALS
+
Select the desired parameter and confirm with OK.
+
With the keys or , modify the parameter settings by
following the table below and press OK.
Parameter Setting Signification
1 - SCANNING
MODE 1 - NORMAL
2 - FINE
3 - SFINE
4 - PHOTO Default value of the scan mode resolution for the
documents to be transmitted.
2 - TX HEADER 1 - WITH
2 - WITHOUT If this parameter is on, your header will appear
on all documents sent to your subscribers with
your name, number, date and number of pages.
Note: In the United States, as required by
FCC regulations, a heading must be
included on all FAX messages.
3 - TX SPEED 1 - 33600
2 - 14400
3 - 12000
4 - 9600
5 - 7200
6 - 4800
7 - 2400 Transmission speed for outgoing documents.
For a quality telephone line (compatible, no
echo), communications occur at maximum
speed.
However, it may be necessary to restrict the
transmission speed for some calls.
4 - ECHO
PROTECT 1 - WITH
2 - WITHOUT If this parameter is on, the on-line echo will be
reduced during long distance calls.
6 - EPT MODE 1 - WITH
2 - WITHOUT For some long distance calls (satellite), the
on-line echo may disturb the call.
7 - COM.
DISPLAY 1 - SPEED
2 - PAGE
NUMBER
Choice between transmission speed displayed or
number of the page in progress.
8 - ECO ENERGY 1 - WITHOUT
2 - DELAY 5 MIN
3 - DELAY
1 5 MIN
4 - DELAY
30 MIN
5 - STDBY
PERIOD
Choosing the printer standby delay: the printer
will switch to standby after a delay (in minutes)
of NON-operation or during the period of time of
your choice.