Roland VS-2480 - Manual (Page 98)

7—Project and Drive Operations
98 www.rolandus.com Roland VS-2480 Owner’s Manual
Amount of Recording Time with Each Recording Mode
This chart shows the number of minutes you’d get when recording a single track in a
single 10G partition. The available time depends on the selected sample rate.
Creating a New Project
1. Press PROJECT.
2. If “NEW” isn’t visible above F2, press PAGE until it is.
3. Press F2 (NEW)—the PROJECT NEW screen appears.
4. Set the Copy System Prm parameter to:
•
Off —to create a new project with default UTILITY menu parameter values
(UTILITY menu parameters are described in Chapter 28).
• On —to copy the current project-related UTILITY parameter values into the
new project.
5. Set the Copy Mixer/Scene Prm parameter to:
•
Off —to create a new project with default mixer settings and no scenes.
• On —to copy the mixer settings and scenes from the currently loaded project
into the new project.
6. Select the desired sample rate and recording mode (Page 96).
7. Name the new project.
Mode: 96k 88.2k 64k 48k 44.1k 32k
M24 662 721 993 1,324 1,442 1,987
MTP 1,989 2,165 2,983 3,977 4,329 5,966
CDR 994 1,082 1,491 1,989 2,165 2,983
M16 994 1,082 1,491 1,989 2,165 2,983
MT1 1,989 2,165 2,983 3,977 4,329 5,966
MT2 2,651 2,885 3,976 5,302 5,771 7,953
LIV 3,181 3,462 4,772 6,362 6,925 9,543
LV2 3,977 4,329 5,966 7,955 8,558 11,932
Since scenes remember effect patch edits, copying scenes lets you move effect settings
from the current project into the new one you’re creating.
You can re-name the project later on—and add a comment, if you like—using the
project NAME operation (see Page 99).
PROJECT menu
F2 (NEW)
VS2480OMUS.book 98 ページ ２００６年２月７日 火曜日 午後４時１６分